If I'm not mistaken isn't there an "Undo last 50 triangles" button in the mesher? We're looking at adding some more explicit mesh control but I can't give an eta on that at the moment.
Thread Rating:
|
delete some parts from the mesh
|
|
|
| Messages In This Thread |
|
delete some parts from the mesh - by db00 - 10-12-2013, 10:24 AM
RE: delete some parts from the mesh - by raty2021 - 10-25-2013, 05:59 PM
RE: delete some parts from the mesh - by Antifg - 10-25-2013, 07:15 PM
RE: delete some parts from the mesh - by raty2021 - 10-28-2013, 03:32 PM
RE: delete some parts from the mesh - by saven - 10-28-2013, 07:54 PM
RE: delete some parts from the mesh - by ferenz - 10-28-2013, 09:05 PM
RE: delete some parts from the mesh - by saven - 10-29-2013, 04:14 AM
|
Users browsing this thread: 1 Guest(s)